• Lg Intellowasher 7kg

I need a manual for lg intellowasher 7.2kg wd 80130f please? Washing Machines. Electronics service LG WD-10130F WD-10130 F manual, review.

Unplug the unit then open the trap back up, remove the trap completely and see if you can reach in with a finger to the pump and spin the impeller you should feel it move to the next postion or you may find some small piece of debris that is stopping the impeller from turning. Unplug the unit then open the trap back up, remove the trap completely and see if you can reach in with a finger to the pump and spin the impeller you should feel it move to the next postion or you may find some small piece of debris that is stopping the impeller from turning. 901 Answers SOURCE: You are right!

Bearings have to be replaced. Replace with the same type and design. All the bearings connected to the washer center shaft has to be replaced at the same time with new set. Replace the water seals also connected to this.

Lg Intellowasher 7kg

Check the shaft where the bearing sits, for any abrasions or metal damage. Check the bearing housing also. While carrying out these repairs check the drive belt also. If needed replace it. If you are happy with the machine outer body and other aspects repair it and re-use it.

Posted on Apr 07, 2010. 6277 Answers SOURCE: Hi from retired Englishman in SW France, 'dE' stands for 'drain Error'. I would gently suggest as a first step that you clean the drain motor/pump lint tray/filter. So many 'faults' are caused by blocked filters and many machines will not even go to rinse or spin or release the door lock if there is any water still left inside.

Following are my complete and generic guidance notes for checking both the drain motor filter and the drain motor;-0) REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT (alternatively use a wet vac as sensibly suggested by VinnyB1234!) If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!). These panels are either held on by (plasic) screws or will just pull off.

Most filters are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play. It's surprising what people have found in theirs!

It is always worthwhile checking it on a regular basis. Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!

At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning.

If this has assisted you please consider a 4 thumbs up for the rating. Thanks and good luck! John C Posted on Aug 01, 2011.

. 901 Answers SOURCE: You are right! Bearings have to be replaced. Replace with the same type and design. All the bearings connected to the washer center shaft has to be replaced at the same time with new set. Replace the water seals also connected to this. Check the shaft where the bearing sits, for any abrasions or metal damage.

Check the bearing housing also. While carrying out these repairs check the drive belt also. If needed replace it. If you are happy with the machine outer body and other aspects repair it and re-use it. Posted on Apr 07, 2010.